Apply glue to the mortise and tenon joints and reassembly the
end assemblies.
Place the side assemblies into a clamp and let dry over night.
Be sure to wipe of any excess or glue squeeze out with a damp rag.
Make sure the legs are square and are dry before continuing to the next step.
Apply glue to the cleats and attach with screws.
Apply glue to the mortise and tenon joints of the center rails and place into the legs.
Insert the shelf and attach mounts with screws.
Place the unit into a two clamps and let dry over night.
Be sure to wipe of any excess or glue squeeze out with a damp rag.
Make sure the bottom unit is square before continuing to the next step.
Note: The spindles are not shown, but they should be installed before
gluing up the sides.
